How To Connect Backup Camera To Hu
Red Wire : This wire provides 12 Volt (V) power to your back-up photographic camera. This tin can be connected to any 12V power source on your vehicle. However, it'south recommend to connect to your opposite lights and then the camera just turns on when the vehicle is in contrary. Note: If your vehicle is equipped with trailer wiring, it'due south recommended to connect to the 12V reverse light wire contained within your trailer wiring harness. Delight refer to the wiring diagram(s) for your specific vehicle and/or trailer harness to make up one's mind the correct color 12V wire for the opposite lights.
Tip : "Scotchloks" are an easy way to connect to an existing wire on your vehicle without damaging or cut the factory harness. These can be found at common hardware stores.
Black Wire : This is a ground which can be continued in several ways including the ground wire within your trailer wiring harness, any other ground wire at the rear of your vehicle, or connecting direct to the steel frame/chassis. If connecting to the frame/chassis, use sand paper or abbrasive to clean the contact surface to ensure a reliable ground.
Video RCA Cable (Yellow Connector)
This provides a video signal and connects straight from the back-upwardly camera to the video input on your monitor or head unit (HU) within the vehicle. Routing this cable is the nearly labor intensive part of the installation. Be certain to carefully route the video cable from your dorsum-up photographic camera all the fashion to your vehicle'south dash and avoid heat sources, precipitous edges, or anything else that could damage this wire. Use null ties along the style to secure the wire.
Ruby Wire Attached to Video Cable : This is an optional 12V "trigger" wire used when your monitor or HU has a contrary signal input. Monitors and HU'south which are multi-functional demand to know when the vehicle is in reverse in order to switch the display to the back-up camera. This wire should exist connected to the 12V contrary lite source at the rear of your vehicle (the same 1 used previously), and the other stop should be connected to the reverse signal input on your monitor/HU (if applicable).
Annotation: If you programme to use a dedicated monitor for the back-up photographic camera, the trigger wire is non needed. Instead, but connect your monitor's 12V power wire directly to the reverse lights and then the monitor only turns on when the vehicle is in reverse.
Guidelines and Camera Orientation
Your photographic camera is equipped with two small wires attached to the primary harness which control both the guide line feature, and the orientation. Cutting and/or re-connecting these wires affect your camera equally follows:
White Wire – Camera Orientation
Connected =Front Facing (default)
Disconnected = Rear Facing
Green/Bluish Wire – Due north o Lines (default)
Disconnected = Lines
Annotation: In nearly applications, it will be necessary to cutting the white wire.
After making a alter to these wires, disconnect the camera from ability and re-connect to detect the alter.
Do y'all know that yous can utilize the TTP-C12B Rear view camera as a subconscious security surveillance camera?
You volition only demand a BNC to RCA Cable, and just connect the camera to your DVR system.
Source: https://toptierpro.com/blogs/news/first-post
Posted by: looneymarn1977.blogspot.com
0 Response to "How To Connect Backup Camera To Hu"
Post a Comment